Specifications

I n s t a l l i n g t h e

d i g i t a l v i d e o

p r o c e s s o r

To connect a composite video source (eg VHS video recorder)

DVP1080HD Digital Video processor

VHS Video recorder

COMPOSITE OUT

This option should only be used with low-quality sources where no other output format is

available.

• Connect the composite video output from the source to the VIDEO input on the

DVP1080HD.

To select the source

• Press Video on the remote control.

Note that older VHS tapes and decks may cause an unstable image. In addition, a distorted

image is normal during FFW, RW, and pause. A timebase corrector can be added to help

stabilise the image.

To connect a computer monitor output

• Connect the computer monitor cable to the pass-through input on the DVP1080HD

using a D15F cable.

This allows high scan rate analogue signals to pass through to the display device. Signals

are not processed or transcoded (YPrPb-RGBHV).

Analogue cables must be connected from the processor to the display to get an image from

this input. If the signal on the input is 5-wire RGBHV, the analogue cables on the output

must also be 5-wire RGBHV.

Be sure the display device is compatible with the signal type being sent through this input.

Use a BNC to D15M breakout cable to connect to the source. To prevent ringing and signal

loss do not use D15 to D15 cables longer than 3m (10’).