User guide

DSP6000 AND DSP6000C
27
It is the nature of all lacquer fi nishes to shrink over time. This is
unavoidable and may result in cabinet joint lines becoming visible.
Meridian Audio has supplied products using lacquer fi nishes for many years
and we are confi dent that when carefully used your product will return a
lifetime’s enjoyment.
To fi t the feet
The feet ensure that the loudspeakers have a stable base, and can be
adjusted to allow for uneven fl oors. Use the spikes for carpeted fl oors; they
are designed to penetrate the pile without damaging or fl attening the
carpet. Use the protectors for solid fl oors.
Each DSP loudspeaker needs four feet, fi tted as follows:
• Fit a lock nut to each foot, leaving about 2mm of thread between the
lock nut and foot.
• Screw each foot into the threads on the bottom of the base units. Do
not fully tighten the lock nut at this stage.
• On solid fl oors fi t the protectors over the spikes.
• When all four feet have been fi tted, carefully set the DSP loudspeakers
upright in their playing positions and remove the rest of the packaging.
• Adjust the feet until the speakers are stable, and then tighten the lock
nuts.
To install the head units
• Locate the three pillars and screw them into the three holes in the top
of each base unit.
• Fit the glass plate over the pillars on the top of each base unit.
• Fit a plastic spacer over each pillar.
• Place the head unit on top of each base unit.
On the DSP6000 the gold stripes on the head and base units should line up.
The speakers have the correct orientation if the sloping sides on the heads
are to the outside (gold strip inside).
• Connect the end of each head connection lead marked with a red band
to the socket in the back of the head unit.