User guide

Configuring the digital surround controller without a computer
67
To select a Type
● Select a video source to produce an on-screen display.
● Put the digital surround controller into standby by pressing
Off (front panel or remote).
● Hold down the A key on the front
panel until the display shows:
Type in... 5
● Keep holding down the A key for a
further 5 seconds.
The display will show:
Type- Wait..
Followed by the current Type setting;
for example:
Type 5.1 AAA
● Press ▲ or ▼ on the front panel to select the Type.
For example, if you have two analogue
speakers the display shows:
Type 2.0 A--
● Wait for a few seconds, while the
display shows:
Typing, wait
● Press the Off key on the front panel.
The display shows:
Exiting Type