User guide
Table Of Contents
- Contents
- Index
- A
- B
- C
- D
- G
- L
- M
- P
- R
- S
- safety warnings
- sample configurations
- selecting a source
- service
- settings, storing
- Setup mode, selecting
- setup options, configuring
- slave, selecting
- sources
- speaker position, specifying
- specification
- standard settings, selecting
- standby, switching to
- status indicators
- storing settings
- switching to standby
- T
- U
- V
27
CONFIGURING THE
DSP8000
LOUDSPEAKERS
To specify the speaker position
• Press A or V to specify the speaker position.
The options are shown in the following table:
Display Position
L. Left.
R. Right.
C. Centre (Type 6 only).
S.L. Left surround (Type 6 only).
S.R. Right surround (Type 6 only).
To choose master or slave
You should select one loudspeaker to be the master; this will normally be
the centre channel. See Setting up the DSP8000 loudspeakers, page 9. The
other DSP8000 loudspeakers should be configured as slaves as follows.
• Press the green > (Play) key on the remote.
The display shows,
for example:
L. Slv.
When you have configured the loudspeaker:
• Switch off the DSP8000 loudspeaker, using the power switch on the
back, and then switch on again to restore normal operation.