Specifications

Comprehensive upgrade 3-19
Performing a comprehensive upgrade
Standard 1.0 System Installation and Modification Guide January 1998
3 Use the following table as a guide on where to access
information in this procedure.
4 Is the configuration correct?
If Yes, go to step 5.
If No, go to step 6.
5 Press the up or down arrow keys to select Yes, and press
<Return>. The following prompt appears:
Do you wish to enable disk to disk backup?
No (Yes)
Note:
The above prompt will be displayed depending on the
number of hours on your system. For more information on
systems where disk to disk backup is not available, see “Toggle
disk to disk backup” on page 2-12.
6 Press the up or down arrow keys to select No, then press
<Return>.
At this point, the installation procedure aborts. Then do the
following:
a. Power down the system.
b. Correct the hardware fault.
c. Start the comprehensive upgrade again. See “When to use
the procedures” on page 3-10.
Step Action
IF your system is a THEN go to
Modular Option, Modular
Option GP, Card Option,
MSM
steps 4, 5, and 9
Modular Option EC MMP40
or an Option EC-11
steps 4, 5, 7, 8, and 9
IF you select No or Yes
with a THEN go to
Modular Option, Mod Op
GP, Card Option, MSM
step 9
Modular Option EC MMP40
or an Option EC-11
step 7