Specifications

14-46 Software installation
Performing a software installation
Standard 1.0 System Installation and Modification Guide January 1998
4 Press <Return>.
Result:
The T1 Hardware Location table (see below) is
displayed again.
If you are satisfied with the changes, use the up or down arrow
keys to select Done, and then press <Return>. The following
prompt is displayed.
Is this correct? No (Yes)
Note:
At this point in the procedure, that is, if you select No,
Reset and Change are still available as choices if you wish to
do anything to the settings.
5 Is this correct?
If No, go to step 6.
If Yes, go to step 7.
6 Select No, then press <Return>.
Result:
This choice returns you to the Select Operation mode.
In this case, go to step 1.
7 Select Yes, then press <Return>.
8 See “Defining voice hardware locations for the MSM” on
page 14-47.
Step Action
ATTENTION
If after selecting Change again, or Done you receive an
error, there may be an incorrect assignment of the ports
to the link. The error must be corrected before you
proceed.