Specifications

Exit to support level 13-5
Exiting to support level
Standard 1.0 System Installation and Modification Guide January 1998
Exiting to support level
When to use this
procedure
Use this procedure
• if you need access support level utilities
Exiting to support
level
To display the System Installation and Modification Menu, the
System Operation Utility Menu, and the support level prompt,
follow these steps.
Starting Point: Meridian Mail System Status and Maintenance Menu
Step Action
1 Select the “System Status” screen and perform a courtesy-
down procedure before starting on any of the following steps.
Note:
Do this prior to starting any of the procedures described
in this guide to prevent calls from being abruptly terminated
when the operation begins. For more information, refer to the
section “Disabling/Activating the system” in the chapter “System
Status and Maintenance” in the
System Administration Guide
for your platform
.
2 Insert the Install/data tape into the tape drive.
Note:
Refer to Chapter 5 of the
Installation and Maintenance
Guide
(NTP 555-70x1-250) for tape insertion instructions. For
MSM systems, contact your Nortel representative.
3 Turn off the power to Meridian Mail, or press the reset button
on the MMP40 card.
Note:
Reset node 1 first, then nodes 2 through 5 in sequence,
if applicable. For more information on power up and power
down procedures, refer to Chapter 14 in the
Installation and
Maintenance Guide
(NTP 555-70x1-250). For MSM systems,
contact your Nortel representative.
Note:
Card Option systems using external tape drives must
have the tape drive turned on before booting up.
ATTENTION
On Card Option systems, disable the AML link before
turning off the power to Meridian Mail.