Specifications

8-4 Move voice services cabinet
What to do before you begin
Standard 1.0 System Installation and Modification Guide January 1998
What to do before you begin
Checklist
This list of points should be followed before proceeding with
the Move Voice Services Cabinet utility.
• Make sure you have read and understood, see Chapter 2,
“Overview: read me first”.
• Before voice services cabinet is moved to another volume,
always perform a full backup in order to save the data. The
system will not remember where the voice services cabinet
has been moved to and will not copy them from their new
location.
• Disable disk to disk backup.
• Make sure that there is paper in the printer. (If your printer
runs out of paper during the procedure, your screen will
freeze.)
• Enable SEER printing. Go to the General Options Screen
under General Administration in order to do this.
• Enable your terminal’s auto-print mode (<Control><W>
followed by <P>) in order to capture everything that
appears on your screen. If you have to reboot the system
for any reason, you will have to reenable the auto-print
mode.
• Obtain the Meridian Mail Release 12 Install/data tape.
ATTENTION
It is up to the administrator to identify the volume to be
backed up by selecting the volume where the voice
services are located when performing the full backup.
If your voice services have been moved prior to a
conversion to MM12, you need to know what volume
these services are stored in.
For more information, see the chapter on voice services
administration in your
System Administration Guide
(NTP 555-70x1-30x).