Specifications

3-32 Comprehensive upgrade
Performing a comprehensive upgrade
Standard 1.0 System Installation and Modification Guide January 1998
Defining voice port
hardware locations
for Modular Option
and Modular Option
EC
To define your voice channels entries for the Voice Port
Hardware Location table for Modular Option and Modular
Option EC, follow these steps.
Step Action
1 Select Done on the DSP parameters.
Result:
The following voice port hardware location screen is
displayed.
Note:
The table below depends on your system configuration
as defined by your keycode and the installed system hardware.
Your display may differ.
Requirement: You have four selections at the “Select
operations” prompt which are revealed each time you press the
up or down arrow keys. Select
• “DetailedDisplay” if you need to see a detailed display of all
the hardware locations on a particular node or range of
nodes.
• “Change” if you want to change the port definition on a
range of hardware locations on or across nodes and to
modify default values to the switch agent configuration.
• “Done” if you are satisfied with the default values or your
changes.
• “Reset” if you decide to go back to the default settings after
you have changed them.
Chapter 3