- Meridian Controlled Routing Installation And Upgrade Guide

Chapter 19: Single Terminal Access 543
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Table 149
Port configuration
Prompt Response
PORT TYPE System
PORT NAME Meridian Link/CCR
BAUD RATE 9600
DATA BITS 8
STOP BITS 1
INTERFACE RS-232 DCE
EMULATION EM200 8-bit Ctrl
CONNECT SEQUENCE Ctrl-R (Read the instructions under
the function keys on how to enter
this information)
LOGOUT SEQ
Note: Step 20 must be completed for each port connected to a
monitored system.
21 Click <PF7> to proceed to the Port Maintenance Menu.
22 Select ÒEnable portÓ using the up/down arrow keys and press
[Return] to enable the Meridian Link/CCR system port.
STA is now available to monitor both Meridian Link/CCR and the
Meridian 1. You can access Meridian Link/CCR by pressing the
assigned function key as shown on the STA Main Menu. You may
have to press [Return] several times to get a response.
23 To return to the STA Main Menu, press [ESC] and type STA. Press
[Ctrl]+[R] to refresh the screen when needed.