- Meridian Controlled Routing Installation And Upgrade Guide

486 Chapter 15: Link configuration
553-3202-210 Standard October 1998
Procedure 13: Changing AML (link 0) parameters (continued)
Table 141
AML (link 0) parameters
Link parameter Allowed values
(defaults in parentheses)
Description
Protocol* (HDLC) Link protocol used
Link type* (1) Type of link (1=AML)
Machine ID (SL16) Logical name assigned to the
attached Meridian 1
Delay (0)Ð9999 Maximum time (in seconds)
between packet transmissions
Port type* (H) H=HDLC
Physical DTE/DCE 0, 1 0 if link port is configured as
DTE; 1 if the port is configured
as DCE
PDN type 0, 40Ð48 Packet data network type. This
parameter is dependent on the
type of network configured.
The possible values are:
0 Ñ LAPB
40 Ñ Datex-P (Germany)
41 Ñ Transpac (France)
42 Ñ PPS (United Kingdom)
43 Ñ Datapak (Sweden)
44 Ñ Telenet (USA)
45 Ñ DDN (USA)
46 Ñ Accunet (USA)
47 Ñ Datapac (Canada)
48 Ñ Tymnet (USA)
The default values are 0 for
LAPB and 44 for X.25.
Note: Parameters marked with an asterisk (*) cannot be changed.
Ñ continued Ñ