- Meridian Controlled Routing Installation And Upgrade Guide

424 Chapter 14: Software installation, upgrade, and update procedures
553-3202-210 Standard October 1998
Procedure 5: Load the operating system tape on an Application Module
with an MVME147 card (continued)
26 You are prompted to enter the user file system slice number. Press
[Return] to use the default slice number (2).
Phase 2 of the BOS installation begins, and the slice table appears.
Figures 162Ð165 show disk-slicing tables for four different drive
types.
Figure 162
Disk-slicing table for 104-Mbyte disk drive
Phase 2. Configure Root And Usr File-Systems And Swap Area
Check the following slicing information for the root file systemÕs disk
drive; indicate below whether you wish to modify this information:
slice offset sl size fs size fsname vol-id info
0 648 40000 40000 root R3 1
1 40648 20000 0 1h8
2 60648 148484 148484 usr R3 1
3 0 0 0 1h8
4 0 0 0 1h8
5 0 0 0 1h8
6 0 0 0 1h8
7 0 209132 0 1h8
---> Modify any of these parameters? (y, n, ?, q): [n]
Figure 163
Disk-slicing table for 172-Mbyte disk drive
Phase 2. Configure Root And Usr File-Systems And Swap Area
Check the following slicing information for the root file systemÕs disk
drive; indicate below whether you wish to modify this information:
slice offset sl size fs size fsname vol-id K
0 648 60000 60000 root R3 1
1 60648 40000 0 1
2 100648 180000 180000 usr R3 1
3 280648 54827 0 1
4000 1
5000 1
6000 1
7 0 335475 0 1
---> Modify any of these parameters? (y, n, ?, q): [n]