- Meridian Controlled Routing Installation And Upgrade Guide

352 Chapter 12: Meridian 1 configuration for Meridian Link/CCR

553-3202-210 Standard October 1998

Table 133

LD 10ÑCreating a Phantom Set (continued)

Prompt Response Comment

CUST 0-99 Customer number

Press [Return] until the CLS prompt

appears.

CLS NDD No digit display is recommended if

configuring phantom devices.

CLS (DNDD) Dialed Name Display denied is

recommended if configuring

phantom devices.

Press [Return] until the AST prompt

appears.

AST 00 Key 0 is AST.

IAPG (0)Ð15 Meridian Link Unsolicited Status

Message (USM) group. These

groups determine which status

messages are sent for an AST set.

The default 0 sends no messages,

whereas Group 1 sends all

messages.

ITNA (NO), YES Idle TN for third-party application.

Select YES for Phantom TN.

DGRP (1)Ð5 Device group with which phantom

TNs are associated.

Press [Return] until the KEY

prompt appears.

KEY xx SCR yyyy Key number, Single Call Ringing,

CLS xx RLS Key number, Releases.

Ñ end Ñ