- Meridian Controlled Routing Installation And Upgrade Guide

302 Chapter 12: Meridian 1 configuration for Meridian Link/CCR
553-3202-210 Standard October 1998
Enable ESDI port (X81 phase 7 or X11 Release 17)
Commands in LD 48 require a port or link parameter, which is indicated in
the prompts as xx. Substitute the appropriate port or link number when
using the prompts listed below.
Table 107
LD 48ÑLink Diagnostic
Command Comment
ACMS xx Enable and start the ESDI link on port xx
The following commands may be used for diagnostic purposes:
CON ESDI xx Configure link layer for ESDI port xx using HDLC
protocol
DIS ESDI xx Disable ESDI on port xx
DIS MSGI xx Turn off link monitoring for incoming messages on
link xx
DIS MSGO xx Turn off link monitoring for outgoing messages on
link xx
DSC ESDI xx Disconnect the link to ESDI on port xx
ENL ESDI xx Enable ESDI on port xx
ENL MSGI xx Turn on link monitoring for incoming messages on
link xx
ENL MSGO xx Turn on link monitoring for outgoing messages on
link xx
ENXP MSGO xx
yy
Exclude polling on link xx for outgoing messages
with priority levels yy
ENXP MSGI xx yy Exclude polling on link xx for incoming messages
with priority levels yy
ENL MSGI/MSGO
xx
Enable message input/output monitoring (xx=link)
ÑcontinuedÑ