- Meridian Controlled Routing Installation And Upgrade Guide

Chapter 11: Peripheral device cabling interface 279
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
USRobotics Sportster modem
The USRobotics Sportster (14.4) modem allows you to extend the distance
between the IPE Module or the Application Module and any connected
peripheral equipment.
The switch settings are shown in the following table.
Table 102
USRobotics Sportster switch settings
Switch setting Position Description
1 Up DTR Normal
2 Up Verbal result codes
3 Down Display result codes
4 Up Echo offline commands
5 Up Auto answer
6 Up Carrier detect normal
7 Down Load factory defaults
8 Down Smart mode
Note: When dialing up the system, you may need to send several
<BREAK> commands from your remote end to the system in order to
bring up the login prompt. The systemÕs baud rate may be different
from the modem baud rate therefore sending the <BREAK> command
causes the system to cycle through various baud rates. When the
system reaches the correct baud rate, you will see the login prompt on
your remote screen.