- Meridian Controlled Routing Installation And Upgrade Guide

270 Chapter 10: Installing peripheral devices
553-3202-210 Standard October 1998
LaserJet series III printer switch settings
Use the [Menu] key on the front panel to check and set the options. Press
the [Menu] key to access the first group of settings. Hold the [Menu] key
down for about five seconds (the printer is offline) to access the second
group of settings. Press the + or Ð (minus) key until the correct setting
appears to change an option. Press [Enter]/[Reset Menu] to save a selection.
Press the [Menu] key to continue. Press the [Online] key to exit from the
menu.
Table 100 shows the correct option settings for use with CCR.
Table 100
LaserJet series III printer switch settings
Press [Menu] key to see the
following function
Hold [Menu] key five seconds to
see the following setting
COPIES = 01
FONT SOURCE = 1
FONT NUMBER = 00
PAPER = LETTER
ORIENTATION = P
FORM = 066 LINES
MANUAL FEED = OFF
SYM SET = ROMAN 8
AUTO CONT = OFF
I/O = SERIAL
SERIAL = RS-232
BAUD RATE = 9600
ROBUST XON = ON
DTR POLARITY = HI
RET = DARK
PAGEPROTECT = OFF