- Meridian Controlled Routing Installation And Upgrade Guide

Chapter 10: Installing peripheral devices 269
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
LaserJet series II printer switch settings
Use the [Menu] key on the front panel to check and set the options. Press
the Menu key to access the first group of settings. Hold the [Menu] key
down for about five seconds (the printer is offline) to access the second
group of settings. Press the + or Ð (minus) key until the correct setting
appears to change an option. Press [Enter]/[Reset Menu] to save a selection.
Press the [Menu] key to continue. Press the [Online] key to exit from the
menu.
Table 99 shows the correct option settings for use with CCR.
Table 99
LaserJet series II printer switch settings
Press [Menu] key to see the
following function
Hold [Menu] key five seconds to
see the following setting
COPIES = 01
MANUAL FEED = OFF
FONT SOURCE = 1
FONT NUMBER = 00
FORM = 066 LINES
SYM SET = IBM - US
AUTO CONT = OFF
I/O = SERIAL
BAUD RATE = 9600
ROBUST XON = ON
DTR POLARITY = HI