- Meridian Controlled Routing Installation And Upgrade Guide

Chapter 10: Installing peripheral devices 265
Meridian Link Release 5C/CCR Release 3C Installation and Upgrade Guide
Table 97
VT420 Setup values
Global Set-Up
On Line Comm1=RS-232
Sessions on Comm1 70 Hz
CRT Saver Printer Shared
Display Set-Up
80 Columns No Status Display
Interpret Controls Cursor Steady
No Auto Wrap 6x24 pages
Jump Scroll 24 Lines/Screen
Dark Screen Vertical Coupling
Cursor Page Coupling
Block Cursor Style Auto Resize Screen
General Set-Up
VT400 Mode, 8 Bit Controls Normal Cursor Keys
User Defined Keys Unlocked No New Line
User Features Unlocked UPSS DEC Supplemental
8-bit Characters VT220 ID
Application Keypad When Available Update
Communications Set-Up
Transmit=9600 Disconnect, 2 s Delay
Receive=Transmit Limited Transmit
Xoff at 128 No Auto Answerback
8 bits, No Parity Answerback=
1 Stop Bit Not Concealed
No Local Echo Modem High Speed = ignore
Data Leads Only Modem Low Speed = ignore
Printer Set-Up
Set up according to your printer requirements (if any).
Keyboard Set-Up
Typewriter Keys Ignore Alt
Caps Lock F1 = Hold
Auto Repeat F2 = Print
Keyclick Off F3 = Set-Up
Margin Bell Off F4 = Session
Warning Bell High F5 = Break
Character Mode ,< and .> Keys
<X] Delete <> Key
Local Compose Ô~Key
Tab Set-Up
Leave this screen at the default values.