Installation guide

www.merging.com/VCube

Fasten the mounting screw to secure the Sync Board back-plate to the PC frame.

Identify a vacant USB socket and insert the 5-pin plug of the USB cable (supplied), the red wire being pin 1. (This leaves

one half of the dual USB port free for another connection if required.)

Insert the other end of the cable (10-pin) into connector on the Sync Card.

Inserting the video card (VCube SE only):

Make sure the computer is turned off (and unplugged) before installing the video card.

To avoid the possibility of static electricity damage to the PC or the video card please use an anti-static strap to connect

yourself to a known good earth.

Remove the computer covers required to gain access to the peripheral slots.

Locate a free PCIe x4 slot. Remove a slot / bracket for the chosen PCIe slot.

Insert the video card into the chosen PCIe slot.

5.3 VCube Software Installation

Note: You must have full Administrator Access to install VCube.

Note: the AJA video card drivers are installed automatically when the machine is re-booted after a fresh VCube software install. VCube.

You should ALWAYS use the Merging Technologies versions of the AJA drivers and not those included with an AJA retail board or

downloadable from the AJA website (Xena or Kona models) to avoid conicting driver versions with VCube.

Insert the VCube installation media into a suitable drive/USB socket.

With optical media, unless you have disabled the function, the installer will run automatically.

If necessary locate and run the installer manually.

De-select any items you do not require.

Override any warnings about uncertied drivers during the installation process.

•