User manual

Settings : Settings Page
Page 99
Synchronization - TimeCode (Incoming and Outgoing)
TC Frame Rate Shows current TimeCode Frame Rate. Click to drop-down the full list of frame Rates.
Chase TC Source Shows Current TimeCode Chase Source. Click to drop-down the list of all sources avail-
able. LT C, VITC, Sony 9-pin, Midi TimeCode (MTC)
Chase Mode Shows current Chase Mode. Click to change from Hard to Soft or vice-versa
Toggle Chase When checked, Chase is enabled.
Show LTC/VITC Click to open LTC / VITC Settings dialog Please see: LTC / VITC Settings on page 100.
Follow VT When checked, VCube follows Virtual Transport
VCube as VT “Clock Master” When checked VCube is the sync clock master for Virtual Transport
Allow Chasing Across Midnight When checked, chasing across TimeCode midnight is possible 23:59:59:24 changes to
00:00:00:00 one frame later.
Chase Offset Shows current Chase Offset. Click in the field to type an Offset.
Graphic Card Delay Compensation Shows current delay compensation in frames. Click to drop-down a list of values between
-10 and +10
Video Card Delay Compensation Shows current delay compensation in frames. Click to drop-down a list of values between
-10 and +10
Sony 9 Pin Remote Control When checked 9-pin Remote control is active.
Settings Opens the Port COM Settings dialog:
COM1 Current COM Port. Click to drop-down a list of available COM Ports.
Var / Shuttle with Speed 0 When checked VCube issues a Var / Shuttle 0 Speed command when stopped.
Pause When checked VCube issues a Pause command when stopped. Audio data is
retained in buffers.
Stop When checked VCube issues a Stop command when stopped. Audio data is
flushed from buffers.
Debug Log Please see: Sony 9-pin Not Controlling VCube on page 172
Sony 9-Pin Machine Control When checked 9-pin Machine control is active.
Settings Opens the Port COM Settings dialog:
COM1 Current COM Port. Click to drop-down a list of available COM Ports.
Port COM Settings dialog
Port COM Settings dialog