User manual

Transport and Navigation : Transport Tool
Page 55
• Chase Offset Shows the current Chase Offset. Double-click in the field to type or edit the value.
Click on the Store button to store the offset.
• Store Stores the Chase Offset displayed in the Chase Offset field.
• LTC When checked the Linear TimeCode Input is used as the reference.
•VITC When checked the VITC (Vertical Interval Timecode) in the Video is used as the
reference.
•Delta The field indicates any discrepancy between the VCube current location and where it
should be.
• EXT Select to chase serial TimeCode from the Sony 9 pin serial stream. If EXT is not
selected, the displayed TimeCode is the current Virtual Transport TimeCode.
Control of External Machine
When Ctrl is used with the Transport controls the Internal Machine is unlinked for the controls. In this way it is
possible to control the external Sony 9-pin machine to receive control commands directly from the VCube key-
board.
Note: The Internal Machine and Sony 9-pin cannot use the same Serial Port.
Go To TimeCode
The Go To TC function is accessed by Ctrl + Num 6.
Simply type the required TimeCode in the field and click on OK to locate the Playhead cursor there.
Locator - Enter the TC where you want to go... dialog