User manual

Transport and Navigation : Transport Tool
Page 54
Transport > Toggle Transport Tool [T]
If Sony 9 Pin Remote Control is enabled in: Settings > Format & Sync : Sony 9 Pin Remote Control Remote On
is displayed. This means that the Internal Machine is controlled by the Sony 9 pin protocol serial data emanating
from another device. Please see: Remote Control on page 129
If Sony 9 Pin Machine Control is enabled in the same Tab then VCube controls the external machine while chas-
ing its TimeCode. A further Transport Control panel appears below the Internal Machine. Please see: Machine
Control on page 137
• Set In [Num 7]
• Set Out [Num 8]
Are linked to the Timeline Range.
• Goto In [Num 4]
• Goto Out [Num 5]
Are linked to the Timeline Locator controls.
• Rewind [Num 1]
•First press 400%
• Second press 1000%
• Third press 2000%
• Fourth press 5000%
• |>|
• Play [Space (Toggles Play/Stop) or Num Enter (Toggles Play / Pause)]
• Record [Decimal]
• Fast Forward [Num 2]
•First press 400%
• Second press 1000%
• Third press 2000%
• Fourth press 5000%
• Stop [Num 0]
• Loc [Num 6] Accesses the Goto Locator window.
• Loop [L] When checked VCube Plays in a Loop from the In point to the Out point
• Chase [Ctrl + F1]. This button cannot be enabled when using the Follow VT mode in regular
VCube or Slave to VT mode in VCube SE.
Transport Control Panel