User manual

Appendices : ProTools and VCube
Page 234
Preferences / Machine Control tab
•Disable Machine Cues Intelligently.
•Enable Stop At Shuttle Speed Zero.
In Session Setup :
• Ensure that Serial Time Code is used as Incoming Time also ensure Video Ref is set correctly and Choose
the correct fps setting.
VCube configuration:
•In Settings > Format & Sync : Synchronization - TimeCode (Incoming and Outgoing verify that To ggle
Chase is OFF
•In Settings > Format & Sync : Audio Ref Status check that Audio Ref is set to Video Input if you have
connected the Video ref to VCube; otherwise it should be Internal. To verify if the Video reference is
present and correct in the VCube, click on the Show Mykerinos Settings Tab button. The Video Green
Led Highlighted. If the Audio Ref is set to “Video Input”, set Video Red Led should be highlighted too
• Sampling Rate: As required.
• Width: 720 (in SD)
•Height: 480 (in SD)
• Field Order: Lower Field First
• Pixel Aspect Ratio: 0.9 or 1.2 if you are in WideScreen.
• Composition Frame Rate: NTSC (29.97)
• Link Frame Rate: On
• TC Frame Rate: NTSC (29.97)
• TC Clock Ref: “Video Input” if you have connected the Video ref to VCube; otherwise it should be “Internal”.
• TC Clock Ref: NTSC (this settings is available only if “TC Clock Ref” is set to “Video Input”
• Chase TC Source: Auto (we are not going to use the chase but leave the setting as default)
• Chase Mode: Hard (we are not going to use the chase but leave the setting as default)
• Chase Enable: Off Chase Offset: 00:00:00:00
• Graphic Card delay compensation: 0
• Video Card delay compensation: 0
• Sony 9 Pin Remote Control: On
• About Sony 9 pin Remote Control Settings: Shuttle Still Settings: “Stop”
•Serial Port: “COM 2”
• Sony 9 Pin Machine Control: Off