User manual

Machine Control : VCube Controlling & Chasing a Sony 9-pin
Page 138
3. The 9-pin machine is controlled from the VCube Transport Control Panel :
Vcube Chases TimeCode from the target machine.
Note: Ensure that the Reference Video Input on the synchronization panel of the VCube, and the
Video Card Reference Input are referenced to the same genlock, black&burst, or video signal.
This is the only way to ensure precise timing for video signal.
Note: The Record button in the Internal Machine control panel must be enabled only when
"Chasing..." is no longer displayed in the Preview.
Transport Control Panel