User manual

Machine Control : VCube Controlling & Chasing a Sony 9-pin
Page 137
Machine Control
VCube Controlling & Chasing a Sony 9-pin
VCube can remote control and chase another machine via Sony 9-pin (P2 protocol) commands.
The following configuration can be used during capture:
1. In the Format & Sync Tab : Synchronization section configure as below:
Chase TC Source Sony 9 Pin
Toggle Chase Checked
Sony 9 Pin Machine Control Checked
2. The RS-422 configuration switch must be set to To Machine if you use the RS-422 port. This port is named
COM3 in the Settings dialog. This port is named COM2 in the Settings dialog for early VCubes using an ASUS
motherboard. The RS-232 port is named COM1.
Formats & Sync Tab - Synchronization section