User manual

Remote Control : VCube Controlled by Sony 9-pin, Chasing an LTC Source
Page 134
VCube Controlled by Sony 9-pin, Chasing an LTC Source
VCube can be controlled by Sony 9-pin while chasing an LTC source.
1. In the Format & Sync Tab : Synchronization section configure as below:
Chase TC Source LTC
Toggle Chase Unchecked
Sony 9 Pin Remote Control Checked
2. The RS-422 configuration switch must be set to From Controller if you use the RS-422 port. This port is
named COM3 in the Settings dialog. This port is named COM2 in the Settings dialog for early VCubes using an
ASUS motherboard. The RS-232 port is named COM1.
COM1 Current COM Port. Click to drop-down a list of available COM Ports.
Var / Shuttle with Speed 0 When checked VCube issues a Var / Shuttle 0 Speed command
when stopped.
Pause When checked VCube issues a Pause command when stopped. Audio data
is retained in buffers.
Stop When checked VCube issues a Stop command when stopped. Audio data is
flushed from buffers.
3. In this configuration Video and Audio References are optional.
Formats & Sync Tab - Synchronization section
Port COM Settings