User manual

Remote Control : VCube Chasing Pyramix Using Virtual Transport Via Network

Page 130

VCube Chasing Pyramix Using Virtual Transport Via Network

VCube can be remote controlled by and chase Pyramix across a network via Virtual Transport.

When Synchronize Editing with Pyramix is active in the Composition Tab every Video Clip handle move in Pyra-

mix will be visible in the VCube outputs. The frame displayed while moving handles is at the TC position of the

handle moved in Pyramix. Network must be enabled in Virtual-Transport.

[Alt + V] opens the Virtual Transport Server User Interface. Click on the red Net button to open the Network

Frame:

DARKMATERIALS is the Pyramix workstation.

ROHMER is the VCube workstation.

1. Click on the Enable Network check box to enable the Network.

Note: This must be done on both machines.

2. Drag the workstations from the right-hand column to the left-hand column.

Notice that the first workstation dragged across is set as TC Master automatically. This can be changed later if

required.

Virtual Transport Network Frame