User manual

Settings : Settings Page
Page 117
Audio Outputs Quick Routing
Routing of 8 first channels Applies to the first 8 Layers (Channels) in an Audio Track. Default is (Monitor Stereo)
Select from the drop-down list to route to Mykerinos or AJA outputs etc. where these are
installed.
ASIO Driver
Enable ASIO When a properly installed driver is selected Enables the driver when checked.
Driver Select the appropriate ASIO Drive from the drop-down list.
ASIO Panel Click on the button to access the ASIO Control Panel for the Driver Selected.
Dolby E Decoder
Enable SurCode for Dolby E decoding When the correct Dolby E authorizations are present on a Minnetonka iLock click on
this button to enable Dolby E decoding.
Dolby E Input Select the odd and even pair of Audio channels which contain the Dolby E encoded
audio.
(From 1 & 2 to 23 & 24)
Out channels Re-ordering Choose the order in which the decoded channels are to be output. Options are:
ITU (no reorder): 1L 2R 3C 4LFE 5Ls 6rS 7Lt 8Rt
“Pyramix”: 1L 3C 2R 5Ls 6Rs 4LFE 7Lt 8Rt
Analog Tape: 1L 5Ls 3C 6Rs 2R 4LFE 7Lt 8Rt
DTS Music 1L 2R 5Ls 6Rs 3C 4LFE 7Lt 8Rt
Stereo first: 7Lt 8Rt 1L 2R 3C 4LFE 5Ls 6Rs
Dolby E Status Shows the Status of the Dolby E decoder e.g. Disabled or 2 Programs: 5.1+2 etc.
Note: When 'Dolby E decoding' is enabled, all types of audio outputs (analog through an audio
board or an SDI connection etc, but also 'logical' outputs such as audio wrap or rendering) use
the Dolby E decoder output.
Isis Controller
The ISIS remote control from Merging Technologies is supported by VCube. VCube SE does not support this fea-
ture.
Please refer to the Isis User Manual for full operational and Isis specific settings details.
Isis Controller Tab page