Installation guide

Installation Guide : MassCore - Ravenna
9 - 25
Configure Ravenna in the VS3 Control Panel
1. Launch the VS3 Control Panel (Start: All Programs > Merging Technologies > VS3 Runtime > VS3 Control
Panel
2. Cores Allocation Leave on the default setting for now.
3. Latency Leave on the default setting Low Latency (only mode supported at present)
4. Select Platform : MassCore
5. Select Hardware : On Bus as Ravenna (box ticked)
6. Audio Bridge : Set as required.
7. Click on the OK button.
8. When the VS3 panel Do you want to save routing? dialog box appears, click on OK
9. the VS3 control panel will close.
Before First Launch
Before launching Pyramix V8, you must ensure that a PTP Master* is present on your Ravenna network. Merging
Technologies recommends using its Horus converter as PTP Master.
* The Precision Time Protocol (PTP) is a protocol used to synchronize clocks throughout a computer network.
Note: As of V8.0 Ravenna mode only supports Low Latency mode. (VS3 Control Panel)
To enable Ravenna I/O connections please refer to the separate Ravenna Easy Connect
Guide.
Note: Horus users should refer to the Horus User Manual for configuration set-up with
Pyramix.