Installation guide

Merging Technologies
Le Verney 4, CH-1070 Puidoux Switzerland
www.merging.com/Pyramix T : [phone] • F : [phone]
 Pressing the Control key when clicking on the [FL] button, will reduce the Mixing console to the
only components participating to the signal flow. Control clicking again restores the mixer to its
original state
 There are four new menu in the main Pyramix Selection menu:
• Show Selection Console Signal Flow: To display the signal flow on the console of the
current clips selection on the timeline
• Toggle Selection to Console Mapping: To toggle both above actions with a single
command/keyboard shortcut
• Map Selection to Console: To reduce all components of the console to the signal flow of
the current clips selection on the timeline
• Reset Console Mapping: To restore the console the its original state
Groups:
 Pressing the Control key when moving a VCA master fader disables the delta between the faders
in the group
Strips Multi-Selection:
 Strips in the console can now be multi-selected
 Click on a Strip then press Control and click on other Strips number to add remove other strips
 Click on a Strips then press Shift and click on another Strip number to select a range of Strips
 When Pressing Control + Shift the following actions are performed on all highlighted strips:
• Double-click on any Faders, Gain Knob or Pans to reset them
• Move Faders or Gain Knobs and preserve their delta
• Click on any On/Off, Mute, Solo, IP, Phase, Record Ready, etc… Any buttons
• Adding strips in VCA groups
• Adding Effects (Support for VS3 effects)
• Copying Effects (Support for VS3 effects)
• Stem change
 When Pressing Shift only the above behavior is performed on ALL strips.
 When Pressing Control + Alt on a MultiBus Matrix router the patching is performed on the selected
strips by incrementing the patched slot for each strips
Strips :
Rearrangement:
 Strips can now be moved directly in the console UI
 Only Input Strips, Groups and SubGroups can be moved. The Masters Strips cannot.
 Using menu:
• Select one or more Strips
• Select the menu Strip > Copy Selected Strips
• Select a destination Strips <x>
• Select the menu Strip > Paste Copied Strips Before <x> or Paste Copied Strips After <x>
 Using Drag & Drop:
• Select one or more Strips
• Press Control + Shift + Alt
• Drag the selected Strips onto any other Strips
Note: If a SubGroup is not moved, i.e. sitting on the right side of every input strips, it stays in
place when scrolling input strips. When moved in the middle of other input strips it is then scrolled
with them.
Level :
 Increase resolution of .1 dB on all gain controls when using CTRL as a modifier in the mixer
Side effects / limitations:
 The Double-Rows mode of the mixer is no longer supported
 The Control and Shift modifiers used to change the Auto-Write and Release Automation Mode are
no longer supported. They have been replaced by the per-strip mode
MeterBridge and SubGroups:
 The MeterBridge and the SubGroup now follow the same behavior than in the main Mixer, i.e.
Examples:
• If they are positioned at the far right, after all input strips, they are not scrolled with input
strips and remain always visible near the busses masters, and are displayed on the second
row busses section of the MeterBridge