Installation guide

Merging Technologies
Le Verney 4, CH-1070 Puidoux Switzerland
www.merging.com/Pyramix T : [phone] • F : [phone]
Pyramix 9 Release Notes
New Features
Pyramix full 64 bit Support:
 Pyramix v9 has been ported to 64bit. This means a big gain when using project that demand a
great amount of Memory.
Mixer ReVamp:
The Pyramix mixer went though a revamping. Please refer to the description below for details on the
updates and new features.
Coloring:
 The Strips and Busses colors are now displayed in the background of the components.
• Two buttons have been added the right side of the mixer to show/hide these coloring
 [SC] Strips Coloring
 [BC] Buses Coloring
 The selected Strips are now properly highlighted on the whole strip surface.
 The selected Busses are now properly highlighted on the whole surface as well as on their Master
Strip.
 The VCA Groups have a color that is displayed on the VCA master fader and on all faders in the
group
• A new button, [GC], on the right side of the mixer to show/hide the Group Coloring.
 The Routing Page now displays the Strips and Busses colors
 The Automation status of all components is now displayed as a background color. See details
below under the Mixer Automation changes.
Sections:
 Mix Busses, Aux Busses and Effects are now grouped by sections. Each section has a header to
visually separate them.
 Sub Groups are now displayed in the Input Strips section for better readability and to allow multi-
selection actions.
 The Mix and Aux sections have a popup menu available by clicking on a [+] button on the right of
the section header to focus on a given bus. This menu also allows for collapsing or expanding all
busses in the section.
 Clicking on the Aux VU-Meter focuses that bus
Aux busses:
 The Aux Busses now have a VU-Meter in display.
 Stereo Aux busses in “Disabled IP” state, will display a pan or balance button for the mono or
stereo strips feeding it.
Effects:
 The effects section will show empty effects slots. Left clicking on an empty slot will show the Add
Effect menu
Preamp:
 The Message displayed when loading a project to update the Preamp settings of the Horus has
been updated for clarification
 The PreAmps gain will now go from 0dB to +66dB
Automation:
 The Automation modes have been redefined to match industry standards.
 These new modes are displayed on the bottom of the mixer for each Strips.
 The new modes are a concatenation of the former Automation modes and Automation Auto-Write
modes:
• Touch (former Auto-Write + Write & Release)
• Latch (former Auto-Write + Write & Hold)