User manual

User Manual : Creating and Configuring Mixers
User Manual
75
Direct X Plug-ins
To add a Direct X plug-in the procedure is the same except select Direct X Plug-In or Add Direct X
Plug-In.
Note: Plug-ins cannot be added to Monitor Busses and DirectX Plug-ins can only be
added to Input Strips or used in the FX Rack. Please see: Effects Rack on page 258
Further Mixer Configuration Options
Mixer Context Pop-up menu
The entries on this menu vary according to where you right-click on the mixer surface. At the top of the
menu the entries concern the specific mixer component under the mouse cursor when you right click.
The next section of the menu has entries which affect the Strip. Entries from Mixer to the end of the
menu affect the entire mixer and are available wherever the mouse is right-clicked.
Mixer > Show
Show All Makes all input strips and busses visible
Show / Hide > Selects Strips and Busses to be shown or hidden. When checked, the Busses or
strips are visible on the console surface. Both Show and Hide access the same
lists.
Minimize When checked, Mixer window is minimized
Automation >
Isolate These menu choices toggle the Automation mode for the entire
Play mixer. Please see: Automation on page 192
Record
Auto-write
Memory > The choices here enable mixer presets to be saved loaded and managed.
Please see: Storing and Recalling Mixer Presets on page 77
Settings >
General... Opens the Mixer Settings window Please see: Mixer Settings on page 112
Enable Delay Compensation Enables Delay Compensation for the mixer
Dithering Opens the Dithering window. Please see: below and Dither on page 247
for an explanation of the need for dither
Remove Select All Strips , All Buses or All to remove groups of mixer components or
every component.
Mixer Show / Hide pop-up