User manual

User Manual : Strip and Bus Tools - Plug-ins
User Manual
209
Inverse switch
Switches the between normal and inverse expander modes.
Attack/Release/Hold controls
The Expander Section uses the settings of the Attack/Release/Hold controls in the Dynamics Sec-
tion to control it’s timing.
Equalizer section
A fully parametric five band equalizer. Each band covers the entire frequency range from 20 Hz to 20
kHz (or higher, depending on the sampling rate of the project) and can be switched between peaking,
high or low shelving and low-pass or high-pass characteristics. Each of the five bands can be switched
off. De-activated bands do not consume DSP power.
Show/ Hide EQ Section
EQ section on/off
Threshold
Input level
Output level
Threshold
Input level
Output level
Expan der normal mode
Inverse mode
Expander normal and Inverse mode action
EQ Section On/Off
Band Filter Type
Band Selector
Gain Control
Frequency Control
Show/Hide EQ Section
Pre-Dynamics Switch
Graphic Display Window
Selected Band On/Off
Q (Bandwidth) Control