Specifications

from 0 dB to -12 dB
Input Gain (4)
Unit: dB - Value Range: -12 / +12 - Step: 0.01
Default Value: 0 dB
Sets the gain applied to the dynamic processing input.
Threshold (5)
Unit: dB - Value Range: -12 / 0 - Step: 0.01
Default Value: 0 dB
Sets the threshold of the limiting action. This value is displayed into the input peak meter.
Knee (6)
Unit: dB - Value Range: 0 / +12 - Step: 0.01
Default Value: 0 dB
Sets the smoothness of the transmission curve for the limiting action. The curve is smoothed above the threshold value. The
transition range between the linear transfer to the fully limited transfer is set by the knee value.
Output Gain (7)
Unit: dB - Value Range: -12 / +12 - Step: 0.01
Default Value: 0 dB
Sets the global gain applied to the dynamic processing output.
Link (8)
When enabled the knee value reflects the threshold value. Setting the threshold also sets the knee.
Release Mode (9)
Default Value: Auto
Three release modes are available for the envelop of the dynamic processing.
Manual corresponds to the value you have set.
Auto enables our specific algorithm to generate a signal dependent value to avoid typical pumping effects.
Advanced gives access to two different values for release and to the control of the velocity of the variations between the
maximum and the minimum release values.
Maximum Release (10)
Unit: ms - Value Range: 0.36 / 2000 - Step: variable
Default Value: 512 ms
Sets the manual release value and the maximum release value when in Advanced Mode.
4.4 Pure Series II Pure Limiter II
85
4