Specifications

Level difference between in and out (17)
Vu-meter not peak-meter, referenced to -16 dB Fs by default. The scale is +/- 12 dB.
This is the compression, decompression, expander and de-expander summing envelop which also takes account of the input
and output gains of the band.
Dynamic Activity Display (18)
No scale
The current Hysteresis Threshold value is reflected by two green lines on the Dynamic Activity display.
For Compressor and DCompressor sections, the hysteresis action is effective only when the orange Dynamic Activity ()
exceeds the area between the two green lines.
For Expander and DExpander sections, the hysteresis action is effective only when the orange Dynamic Activity () stays
inside the area between the two green lines.
Instant Release Value (19)
Auto Scale depending of the release value(s)
Resulting Transfer Curve (11)
Auto Scale depending of the threshold value(s)
The Side Chain EQ Section:
The band selection can be done with the 1, 2, 3 switches or directly from the graphic display.
All band parameters can also be set using switches and knobs or from the EQ-Curve graphic display as described below.
A Double-click in the graphic display area of the EQ-Curve magnifies it. A new Double-click toggles it back to a reduced size.
From a Right-Click on this area, the behavior of the vertical scale can be selected. Auto, 6 dB, 12 dB and 24 dB are the
possible choices.
In (39)
Default Value: 0ff
Enables the complete EQ section on detector section.
Solo (40)
Default Value: 0ff
The equalized detector signal can be monitored through the plug-in output when the solo button is enabled.
1-2-3 (41)
Default Value: none
Three equalization bands are available on the detector section. Each can be selected to use the parameter knobs for
4.3 Solera II Dynamic Processing Parameters Detailed
40
4