User manual

www.merging.com/horus Page 5 - 9
Horus Release Notes
 Improvement : Limiter added to avoid noise when overloading input in DSD
 Fixed. Horus monitor jack provides the same channel on both outputs (8FS only)
 Fixed. Phase invert now working in DSD
Fixed in Firmware version 20084:
 Improvement: DSD256 noise floor improvement
 Improvement: DSD256 removed DC offset
 Improvement: DSD64 and DSD128 support
 Improvement: Added support for 720p 23.98 video format
 Improvement: Display Audio Data Format in I/O & Sync page (A/D, D/A, Monitor Jack)
 Fixed. Remove inadequate warning about SSRC mismatch
 Fixed. Remove Inadequate warning about Power Supply redundancy
 Fixed. RAVENNA ALC i/o rename would make Horus crash
 Fixed. DSD / DXD indication discrepancy in "Format" page
 Fixed. Horus Web access: Not updating Pyramix PreAmps changes correctly
Fixed in Firmware version 19802:
 Improvement: 384kHz and DXD support
 Improvement: Horus Error report (on Horus TFT)
 Improvement: Pull Up / Pull Down support when locked to video reference
 Improvement: AD module Mic alignment selector
 Improvement: Horus Monitor module: Stereo channels routing selector (1-2/3-4/5-6/7-8)
 Improvement: Fan, cooling mode set to low at start up only (to avoid noise)
 Improvement: WebApp: At the browser opening we automatically open the latest page
chosen by the user
 Fixed. Clicking noise on some AES input channels with long cabling at 96kHz
 Fixed. Horus: MADI input sync color display was not correct on the Web access page
Fixed in Firmware version 19243:
 Improvement: Added MADI “96k Frame” Option (High Speed) for MADI output. This option is
only available at 88.2/96kHz sampling rate.
 Fixed. Web Access, MADI extension 2 not visible in routing
Fixed in Firmware version 18935:
 Fixed. Module serial number not readable from Horus TFT
 Fixed. RAVENNA i/o could end up muted due to video sync reference changes
 Fixed. Horus Web Access I/O & Sync page was showing a quick red led, misleading status
 Fixed. Horus: LTC out mute on stop, wrong last LTC decoded when stopping
 Fixed. Horus: Monitor Jack clicks when the sample rate is changed
 Fixed. Horus: Web Access faders optimization to the grouped PreAmps
 Fixed. Horus: DA8/DA8P modules clicks when the sample rate is changed