User manual

www.merging.com/horus Page 49
Horus User Manual
None: Sets the module so that it does not receive a signal from anywhere. Digital
Mute will be output.
RAVENNA: Connects the module to the RAVENNA network and allows any other
RAVENNA device to send signal to it.
AES 1-3: Sets the module being configured to receive signal from any of the 3 banks of
4xAES-EBU input pairs.
MADI 1-2: Enables the module being configured to receive signal from any 8-channel
bank in either of the MADI streams (MADI 2 appears only if the MADI
Expansion Card is fitted.)
A/D N: Sends the signal coming in from the Mic or Line input modules to the output
module being configured
Loopback: Should only be used for test purposes.
Presets Menu (Setup)
Load: 5 presets banks of different Horus configurations can be loaded (one at a time)
Save: 5 presets banks are available to store different Horus configurations
Auto Save: If enabled the save configuration will happen at every 2 minutes.
Note: Since the flash memory which is at the heart of the Horus storage has a
huge (but not infinite) amount of write cycles, we limit the auto-save of all
configuration and PreAmps settings to once every two minutes if (and only if) a
change has occurred meanwhile.
Furthermore, both Shutdown and Reboot buttons (in Setup page) do also
entirely save the current configuration of the Horus prior to power down.
Reboot to Factory: If selected we will reboot the Horus to the default factory configuration. The
Current configuration will be lost but all the saved presets will be kept and can
be reloaded.