User manual

www.merging.com/horus Page 23 - 54
Horus User Manual
3. Open the Horus top panel, remove the AD8/AD8P or D/A8/DA8P modules that could be
obstructing the MADI module access
4. Disconnect the ribbon cable carefully
5. Screw the 2 spacers onto the MADI 1 / AES board
6. Carefully slide the MADI extension board so that the output connectors come out of the Horus
back panel. You will need to do so with an angle that should allow you to push and fit into the
header of the MADI 1 card (below). Align and push gently the MADI extension board so that it
fits in the header.