User manual

www.merging.com/horus Page 16 - 54
Horus User Manual
Connecting the AES-EBU cable
The AES ports connect the AES-EBU I/O using DB25 D-SUB connections.
Please ensure that the cables you have chosen to use, or have had made, conform to this
specification before you attempt to connect them.
To connect the DSUB connection to the AES port, line the Male cable up with the female DSUB port
on the module. Then, with slight pressure, guide the connector into place. If your DSUB connector
has mounting screws on either side, then fasten them to finger-tightness once the cable has been
pushed into place.
Note: The pinout of the DB-25 is as per Tascam Digital.
* THESE CONNECTIONS ARE NOT MEANT TO HOLD ANY SIGNIFICANT WEIGHT.*
Ensure that there is no strain from the connected cable as any significant pressure to the module’s DSUB
connector could damage the Horus unit.