User manual

www.merging.com/horus Page 14 - 54
Horus User Manual
HORUS CABLES
Connecting the analog audio Input cables to the AD8/AD8P modules
The AD/AD8(P) modules connect the Mic/Line Inputs using DB25 D-SUB connections.
Please ensure that the cables you have chosen to use, or have had made, conform to this
specification before you attempt to connect them.
To connect the DSUB connection to the IOC-AD8(P), line the Male cable up with the female DSUB
port on the module. Then, with slight pressure, guide the connector into place. If your DSUB
connector has mounting screws on either side, then fasten them to finger-tightness once the cable
has been pushed into place.
Note: The pinout of the DB-25 is as per Tascam Analog.
* THESE CONNECTIONS ARE NOT MEANT TO HOLD ANY SIGNIFICANT WEIGHT.*
Ensure that there is no strain from the connected cable as any significant pressure to the module’s DSUB
connector could damage the Horus unit.