User manual


Horus User Manual

www.merging.com/horus Page 5
I
MPORTANT NOTICE:
Please read the following information very carefully before attempting any installation. Failu
the precise instructions may r
re to comply with
esult in damage to your Merging hardware. Please read this entire section of the
stallation.
ains delicate electronic components tha
t can be damaged or even destroyed
. Take all necessary precautions not to discharge static electricity when
Converter is designed and
tested to meet the standards and regulations listed in
liance
nts:
 EN 60 950 (European Union).
nal).
he following EMC regulations:
Conducted Emissions (USA).
ated and Conducted Emissions (International).
uation and Flicker).
ing two conditions: (1)
rence received,
und to comply with the limits for a Class A digital device, pursuant to
reasonable protection against harmful
dio frequency
n a particular
n, which can be
ined by turning the equipment off and on, the user is encouraged to try to correct the interference by
ceiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the grantee of this device could void the user’s
authority to operate the equipment. The customer is responsible for ensuring compliance of the modified
product.
Only peripherals (computer input/output devices, Ethernet switches, terminals, printers, etc.) that comply with
FCC Class B limits may be attached to this computer product. Operation with noncompliant peripherals is
likely to result in interference to radio and TV reception.
All cables used to connect to peripherals must be shielded and grounded. Operation with cables, connected
to peripherals that are not shielded and grounded, may result in interference to radio and TV reception.
manual carefully before in
STATIC DANGER NOTICE:
Please note that the Horus cont
when exposed to static electricity
touching any of the Horus connectors.
Product Regulatory Compliance
The Merging Horus Network
the following sections.
Product Safety Comp
Horus complies with the following safety requireme
 UL 1950 – CSA 950 (US/Canada).
 IEC 60 950 (Internatio
 CE – Low Voltage Directive (73/23/EEC) (European Limits).
 EMKO-TSE (74-SEC) 207/94 (Nordics).
Product EMC Compliance
The system has been tested and verified to comply with t
 FCC (Class A Verification) – Radiated and
 CISPR 22, 3rd Edition (Class A) – Radi
 EN45022 (Class A) – Radiated and Conducted Emissions (European Union).
 EN45024 (Immunity) (European Union).
 EN6100-3-2 & -3 (Power Harmonics and Fluct
 CE – EMC Directive (89/33/EEC) (European Union).
Electromagnetic Compatibility Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the follow
this device may not cause harmful interference and (2), this device must accept any interfe
including interference that may cause undesired operation.
This equipment has been tested and fo
Part 15 of the FCC Rules. These limits are designed to provide
interference in a residential installation. This equipment generates, uses, and can radiate ra
ructions, may cause harmful interference to energy and, if not installed and used in accordance with the inst
radio communications. However, there is no guarantee that interference will not occur i
installation. If this equipment does cause harmful interference to radio or television receptio
determ
one or more of the following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and the receiver.
 Connect the equipment to an outlet on a circuit other than the one to which the re