User manual


Horus User Manual

www.merging.com/horus Page 43
None:
the module so that it does not receive a signal from anywhere. Digital Mute will
be output.
Ravenna: RAVENNA network and allows any other RAVENNA
AES 1-3: Sets the module being configured to receive signal from any of the 3 banks of
MADI 1-2: Enables the module being configured to receive signal from any 8-channel bank in
I Expansion Card is
from the Mic or Line input modules to the output
module being configured
y be used for test purposes.
Network Menu (Setup)
Sets
Connects the module to the
device to send signal to it.
4xAES-EBU input pairs.
either of the MADI streams (MADI 2 appears only if the MAD
fitted.)
A/D N: Sends the signal coming in
Loopback: Should onl
Name of the Horus Device Name: unit. This name will be broadcast across the network and will be
it name can be
changed from the Web control access Network page (see section below for all
ystem for
each network interface
Address: Set the IP Address for the Horus unit by using box selection and the - or + buttons
Netmask: Set the Subnet Mask for the Horus unit by using box selection and the < or >
buttons
Apply & Reboot: Once changes have been made to this section, you must press this button to save
the settings and power cycle the Horus unit
seen in applications such as the MT Discovery tool. The Horus un
details)
IP Settings: Manual: Type IP address using box selection and the - or + buttons
Auto: The IP address will automatically be generated by the operating s