User manual


Horus User Manual

www.merging.com/horus Page 42
Routing Menu (Setup)
Module routing menu describes where the signal for each module in the Horus is coming
to that specifi
from. Each button
c module. For
instance, the Monitor Button in the Routing menu will allow the user to change the routing to the monitor.
Choices are made in blocks of 8 channels (except for the Monitor, which is a Stereo signal).
leads to a sub-menu that allows the user to change the source of the signal
Monito Takes you to the Monitor Routing c
MADI 1: he MADI 1 Routing configuration page (refer bel
r: onfiguration page (refer below)
Takes you to t ow)
the MADI 2 Routing configuration page (refer below)
he D/A Routing configuration page (refer below)
ing configuration page (refer below)
A/D: Disabled as one cannot route TO an Input!
Loopback: Takes you to the Loopback module (see above)
Routing: Configuration
Monitor - D/A - AES - MADI Routing Output Source (similar)
MADI 2:
Takes you to
D/A: Takes you to t
AES: Takes you to the AES Rout
For all of the output modules (AES 1-3, D/A N, MADI & Monitor Jack) the user can set where the signal feeding
it comes from. Any combination is possible using the Output source page linked to any of the output modules.
* All routing in the Horus is currently achieved using banks of 8 channels*