User manual


Horus User Manual

www.merging.com/horus Page 39
Modules: MADI Sub-Menu
MADI 1 port is included as standard with each Horus. MADI 2 will be listed as “EMPTY” in Horus units which are
not fitted with the optional MADI expansion card
xtended” (64
ase consult the user
r to see which (if not
complies with.
Physical Mode: al MADI connections
either or, but not both at the
same time. On the Output side, however, both Coaxial and Optical outputs are
High Speed Frame: Choose between using Legacy or High-speed frames. For information on why you
peed) please
us to.
Input: nd use the I/O Connections
utility to activate the I/O
stream connections.
Output Sources: Users can route literally any input signal to any output module. Users can also route
any input signal to any combination of output modules. Signals are routable in
8 chan
ple pi DI ou ing
Mode: Sets the MADI mode to either “Standard” (56 audio channels) or “E
channels). To determine which setting(s) you are able to use, ple
manual of the device you are connecting the Horus to in orde
both) formats it
Choose the input signal to be derived from the Coaxial or Optic
at the back of the Horus unit. You can choose to use
always driven in parallel.
might want to set this to something other than the default (High-S
consult the user manual of the device you are connecting Hor
Enabling Visible to Ravenna will allow Ravenna to “see” a
(seen in the Auto-Connect utility). Use the Auto-Connect
blocks of nels.
The exam cture below shows a MA tput rout
Module AES 1: Routed to MADI channels 1 to 8
Module AES 2: Routed to MADI channels 9 to 16
Module AES 3: Routed to MADI channels 17 to 24
Module A/D 1: Routed to MADI channels 25 to 32