User manual


Horus User Manual

www.merging.com/horus Page 36
System Info
(Set Up):
In this sub menu you will find details on the Horus internals; current consumption, voltage, temperature, fan
speed, serial number and the firmware version currently installed.
Dim active will darken the Horus display luminosity. When active
power and hence some internally generate
Backlight: this saves some
d heat…
Cooling Mode: h reference to
al preferred setting,
ve the setting on Mid
peration and best protective results.
starts rising above 25 °C
: bling this will
75Ω for Video: Sets 75Ω termination for the Video reference Input. Unless the Video
ed to other equipment, you
Shutdown: of the Horus unit, including a save of the current
the Horus unit in other ways (such as
using the power switch on the back of the device).
Reboot: Power cycles the Horus unit (shutdown>Boot up)
Reboot maintenance Power cycles the Horus unit (shutdown>Boot up) and restarts in Maintenance mode
(required mode for Firmware upgrade)
Save Config: Will save all current settings and parameters of the Horus
Settings for either Low, Mid or High Cooling. This affects fan speed wit
the temperature measured internally. While there is no univers
we recommend that unless noise levels are a concern, you lea
or High for coolest o
Low: Fan starts above 45°C
Mid: Fan starts above 35°C
High: Fan always on at lowest speed (less noise), speed
Terminations 75Ω for WCK: Sets 75Ω termination for the Wordclock Input. Ena
disable the Wordclock output.
Reference signal provided to the Horus is daisy-chain
should always terminate your Video signal for most reliable operation.
Initiates a proper shutdown
configuration. Do not attempt to shutdown