User manual


Horus User Manual

www.merging.com/horus Page 26
3. Open the Horus top panel, remove the AD8/AD8P or D/A8/DA8P modules that could be obstructing
access to the MADI module.
4. Disconnect the ribbon cable carefully
5. Screw the 2 spacers onto the MADI 1 / AES board
6. Slide the MADI extension board carefully so that the output connectors emerge from the Horus back
panel. You will need to do this at an angle that will allow you to push and fit the connector into the
header of the MADI 1 card (below). Align and push the MADI extension board gently so that it fits into
the header.