User manual


Horus User Manual

www.merging.com/horus Page 18
Connecting the analo
gue outputs cables to the DA8/DA8P modules
bles you have chosen to use, or have had made, conform to this specification before
you attempt to connect them.
The IOC-DA8(P) modules connect the line outputs using DB25 D-SUB connections.
Please ensure that the ca
To connect the DSUB connection to the IOC-DA8(P), align the Male cable connector with the female DSUB port
nnector has
mounting screws on either side, the er-tight once the connector has been pushed into place.
Note: The pinout of the DB-25 is as per Tascam Analog.
* THESE CONNECTIONS ARE NOT MEANT TO SUPPORT ANY SIGNIFICANT WEIGHT.*
Ensure that there is no strain from the connected cable as any significant pressure on the module’s DSUB connector could
damage the Horus unit.
on th
e module your DSUB co
n fasten them fing
. Then, with slight pressure, guide the connector into place. If