User manual


Horus User Manual

www.merging.com/horus Page 17
HORUS CABLES
Connecting the analog audio Input cables to the AD8/AD8P module
The AD/AD8(P) modules
s
connect the Mic/Line Inputs using DB25 D-SUB connections.
Please ensure that the cables you have chosen to use, or have had made, conform to this specification before
you attempt to connect them.
he female DSUB port
on the module. Then, with slight pre nnector into place. If your DSUB connector has
retention screws on either side, then fasten them finger-tight once the connector has been pushed into place.
Note: The pinout of the DB-25 is as per Tascam Analog.
* THESE CONNECTIONS ARE NOT MEANT TO SUPPORT ANY SIGNIFICANT WEIGHT.*
Ensure that there is no strain from the connected cable as any significant pressure on the module’s DSUB connector could
damage the Horus unit.
To connect the DSUB connection to the IO
C-AD8(P), align the Male cable connector with t
ssure, guide the co