User manual

www.merging.com/hapi Page 67
Hapi User Manual
Note: If you wish to cancel the Hapi Maintenance mode you can do so from the Web access
page or by pressing the small physical power button, this will reboot the Hapi in normal mode.
You can also press the small triangle button in order to reboot the Hapi. Be aware that the small
triangle button is only active for reboot when in Maintenance mode.
Warning: We do not recommend that you refresh the browser page or restart the Hapi while a
firmware update is in progress and we recommend only gigabit Ethernet port or switch
connection. Refer to the Merging RAVENNA Network Guide for example
http://www.merging.com/products/horus/downloads
6) Open the MTDiscovery tool, you should see a device called “Hapi in Maintenance Mode”,
double-click on it.
MT Discovery is installed with Pyramix v8. But for Hapi standalone users it can also be
downloaded from
Note: If you do not see the Hapi Maintenance Mode entry, reboot Hapi in Maintenance mode and verify
your Hapi Ethernet Connection to the MassCore Gb Ethernet Card.
If you still do not see the Hapi maintenance mode under MT Discovery. Open your Windows Device
Manager and look in the Network Adapter section. Disable and re-enable the Merging Technologies PCIe
Ethernet controller.
Warning: Hapi Maintenance mode uses Auto IP config. Therefore en sure that you the PC is configured to
obtain an IP address automatically when performing a firmware update.