User manual

www.merging.com/hapi Page 54
Hapi User Manual
Hapi Web Control access
Installing and accessing the Hapi Control interface remotely
To control and view your Hapi remotely with a web browser make sure that you are using one of the
Internet browsers below: Google Chrome (Highly Recommended), Mozilla Firefox, Opera, Apple
Safari. * Microsoft Internet Explorer is not supported *
Then take the following steps:
1) If you did not install Pyramix v8 or Pyramix v9 proceed from step 2 to 3. If you have already
installed a Pyramix go directly to step 4)
2) Download the MTDiscovery.exe application to your system (PC or MAC installers are available)
http://www.merging.com/products/horus/downloads
3) Make sure your Hapi is connected to the same network as your system, and is configured with
the correct IP settings (See “Setting up the Hapi IP Address”)
4) Launch the MT Discovery tool (MTDiscovery.exe)
Any Hapi devices on the network will be discovered by the MT Discovery tool and will appear in the
folder tree under “RAVENNA Devices>Hapi Devices”
- A mouse double-click on the Hapi Device entry will open the Hapi Web Interface in your default
web browser
- Only Devices on the same network (same color in display) can have their I/O interconnected
- *Microsoft Internet Explorer is not recommended for this*
Using the Webpage, you can browse the Menus and change parameters in exactly the same manner
as on the front panel TFT of the Hapi unit in question.
Warning: It is mandatory that you connect the Hapi to a Gigabit Ethernet Port or Switch for remote
access.
MT Discovery Window